Aluminum Window Frame, Location and Firing System

Sponsored Links :

In building construction and finishes, we recognize several types of Aluminum Window. Below, we provide the information about Aluminum Window Frame, Location and Firing System.

Aluminum Window Frame, Location and Firing System

Aluminum window frame with flushing
This type of aluminum frame located at the external wall of the building and makes direct contact to rain. The aluminum frame shall be placed at the inner side of the wall opening, and at the outer side there will be additional flushing installed along the frame. The aluminum frame shall be fixed to the opening wall using steel anchor bracket every 600 mm, and the frame shall be filled with mortar.

Aluminum window frame with flushing

Aluminum window frame with hardwood
This type of aluminum frame located at the external corridor but no direct contact to rain. The aluminum shall be placed at the inner side of the opening wall and at the outer side, there will be additional hardwood installed along the frame. The aluminum frame shall be fixed to the opening wall using screw & fisher S-8 every 500 mm, and no mortar to be filled in.

Aluminum window frame with hardwood

Sponsored Links :

Interior aluminum window frame and door frame
This type of aluminum frame located at the inside of the building, and shall be fixed to the opening wall using screw & fisher S-8 every 500 mm. The aluminum frame shall be placed at the axis of the opening wall, and shall be fixed to the opening wall and no mortar to be filled on

Aluminum Window Frame Protection and Welding Method
Protection Tape
Every aluminum member shall be protected with protection tape before it is fabricated to prevent from receiving scratch and damage during fabrication process. Protection tape shall be still put on aluminum frame it against mortar and scratch during installation and can only be removed out after all of the works in the building has been completed.
Welding Method and Protection
Temporary protection shall be applied to protect aluminum frame from receiving stain and damage when welding activity is being done. The protection shall be made of thin plywood in sufficient size to cover aluminum frame from the sparkling of welding electrode.

Aluminum door frame with sill on floor
This type of aluminum frame located at wet area (toilet, kitchen. pantry) as it is shown on the location map. Sill shall be made of aluminum or stainless steel and shall be fixed under the door leaf.

Glazing cross section detail
Interior aluminum frame using rubber gasket in fixing the glass
Exterior aluminum frame using silicone in fixing the glass

Stainless steel stretcher guard
Stainless Steel Stretcher Guard shall be pre-fabricated goods, made by stainless steel fabricator and deliver to site in accordance with installation schedule. Shapes and dimension are in accordance with those mentioned on the approved shop drawing.
Stainless Steel Stretcher Guard shall be protected by protection tape, to prevent from receiving scratch and damage, and can only be removed after all of the work in the building has been completed.
Stainless Steel Stretcher Guard shall be fixed on the frame after the aluminum frame is completely fixed

Leave a Reply