Concrete Quality Control Tests in Structural Engineering

Sponsored Links :

Concrete Quality Control Tests in Structural Engineering – This article is about Concrete Quality Control Tests. In this article we are trying to provide you complete information about Concrete Quality Control Tests. We have arranged the information in this post to make you understand it easily. We hope that you can understand it well. Please check the information below.

Concrete Quality Control Tests

concrete quality control tests

Tests for checking quality of concrete should be done for the following possible purposes:

1. To detect the variation of quality of concrete being supplied for a given specification.

2. To establish whether the concrete has attained a sufficient strength or concrete has set sufficiently for stripping, stressing, de-propping, opening to traffic etc.

3. To establish whether the concrete has gained sufficient strength for the intended purpose.

There are so many tests available for testing different qualities of concrete. Different tests give results for their respective quality of concrete. Thus it is not possible to conduct all the tests as it involves cost and time. Thus, it is very important to be sure about purpose of quality tests for concrete. The most important test for quality check of concrete is to detect the variation of concrete quality with the given specification and mix design during concrete mixing and placement. It will ensure that right quality of concrete is being placed at site and with checks for concrete placement in place, the quality of constructed concrete members will be as desired.

Following are the lists of various tests conducted for Concrete Quality:

Tests on hardened concrete:

Compressive strength (cylinder, cube, core)
Tensile strength: Direct tension
Modulus of rupture
Indirect (splitting) Test
Density
Shrinkage
Creep
Modulus of elasticity
Absorption
Permeability Tests on Concrete
Freeze/thaw resistance
Resistance to aggressive chemicals
Resistance to abrasion
Bond to reinforcement
Analysis for cement content and proportions
In situ tests: Schmidt Hammer, Concrete pull-out, break-off, cones etc.
Ultrasonic, nuclear.

Sponsored Links :

Tests on fresh concrete:

Workability Tests (slump test and others)
Bleeding
Air content
Setting time
Segregation resistance
Unit weight
Wet analysis
Temperature
Heat generation

Of these many tests for concrete quality, in practice well over 90% of all routine tests on concrete are concentrated on compression tests and slump tests. It is also desirable to conduct fresh concrete temperature and hardened concrete density determination tests.

The reasons for the selection of compressive strength test and slump test in practice for quality control testing of concrete are:

1. All or most other properties of concrete are related to its compressive strength.

2. Compressive strength test is the easiest, most economical or most accurately determinable test.

3. Compressive strength testing is the best means available to determine the variability of concrete.

4. Slump tests also checks for variation of construction materials in mix, mainly water-cement ratio.

5. Slump test is easy and fast to determine quality of concrete before placement based on recommended slump values for the type of construction.

6. Slump test is most economical because it is done at site and does not require any laboratory or expensive testing machine.

7. Slump tests is done before the placement of concrete, so the quality of control is high as rejected mix can be discarded before pouring into the structural member. So, dismantling or repair of defective concrete members can be avoided.

So that is all about Concrete Quality Control Tests. We think that it is good information about Concrete Quality Control Tests. We hope that this information is useful for you. Please share if you think that this information can be useful for others. If you need more article related to Concrete Quality Control Tests you can simply subscribe this blog. Thanks for visiting and have a nice browsing. source: http://theconstructor.org/

Leave a Reply