How to Use Needle Vibrator for Concrete

Sponsored Links :

How to Use Needle Vibrator for Concrete

This article is about How to Use Needle Vibrator for Concrete. In this article we are trying to provide you complete information about How to Use Needle Vibrator for Concrete. We have arranged the information in this post to make you understand it easily. We hope that you can understand it very well. Please check the information below.

Needle Vibrator

These concrete vibrators are also referred to as poker or immersion vibrator. These are extensively used in building industry. A needle vibrator consists of a cylindrical casing made of steel and is vibrated by means of a flexible drive with an outer tube run from an operating machine which can be run by electricity, petrol, diesel or compresses air. The frequency of vibrations of an immersion vibrator is very important as higher frequency gives better compaction. It varies from 3500 to 12000 cycles per minute. Frequencies below 3500 cycles per minute are inefficient for concrete compaction. The diameter of the vibrating part varies from 20 to 75 mm and its length varies from 25 to 90 cm.

How to Use Needle Vibrator for Concrete

Tips in using Needle Vibrator

The following points are important for efficient use of needle vibrators.

Sponsored Links :
  • When inserting the vibrator into freshly laid concrete, we should hold it upright and drop it slowly to an angle.
  • This method will vibrate a larger area.
  • Pull the vibrator out gradually so that the hole is filled up. It is also necessary o restrict the spacing of the introduction of the vibrator to less than 45 cm (18 inch) apart.
  • We should not vibrate the formwork with a needle vibrator as it will damage the formwork. We should place it only upto 75 mm (3 inch) away from the formwork.
  • When compacting concrete on top of another layer already placed, we must push the vibrator to a small distance (say about 75 mm) into the previously placed fresh lower layer to join the two concretes together.
  • The depth to which the vibrator can be immersed is limited to the position of the flexible drive. The vibrator head can be let down into the concrete to the point of the flexible drive.
  • Do not leave the vibrator running when it is not in concrete. Otherwise it can get heated up and the bearings can break down.
  • Put the whole permissible length of the vibrator in the concrete when compacting fresh concrete. This step is necessary to prevent it from heating up. Immersion in the concrete cools it down.
  • Avoid sharp bend of the flexible drive, especially at the vibrator head. Otherwise great strain is placed on the outer tube and internal flexible drive.

The amount of concrete that can be vibrated by one vibrator per hour varies from 4 to 30 m3 depending on the vibrator and the method of placing concrete.
source : http://civilblog.org/2016/05/17/how-to-use-needle-vibrator-efficiently/.

So that is all about How to Use Needle Vibrator for Concrete. We think that it is good information about How to Use Needle Vibrator for Concrete. We hope that this information is useful for you. Please share if you think that this information can be useful for others. If you need more article related to How to Use Needle Vibrator for Concrete, you can simply subscribe this blog. Thanks for visiting and have a nice browsing.

Leave a Reply